• Create your design using your computer, rubber stamps or drawing.
If your are using a inkjet or laser printer:
Set your printer as follows: Resolution High, Paper Photo Paper
Mirror Image, This is especially important if you are printing text. Your final image will be in reverse of the original.
If you are unsure how to adjust your printer settings consult your owner’s manual for details.
Print your design on the rough side of rub on decal film.
If you are using rubber stamps or drawing:
Rubber stamp or draw your design on the rough side of rub on decal film.
If your are printing and rubber stamping and or drawing we recommend that you print your decal first then apply your rubber stamps
and or drawings.
Suggestions:
If you are not using the entire rub on decal sheet, cut out a portion of the adhesive sheet that will amply cover your printed decal
design.
Also, work slowly and carefully, the adhesive is very sticky and cannot be removed once applied. Smooth away any bubbles as you go.
To remove the backing liners easily bend a corner of the film slightly and backing liner will separate from adhesive.
• Peel away the backing liner from the adhesive sheet, apply the adhesive side of sheet to the printed side of the rub on
decal film.
• Cut out your decal by carefully trimming as close as possible to the rub on decal image.
• Peel away the backing liner that is covering the adhesive sheet and apply the sticky side of the rub on decal film to
a clean dry surface.
• Using a craft stick or coin rub on the decal until it is completely adhered.
• Carefully peel away the frosted film liner to reveal your rub on decal design.
